User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 136 of 199
8. Go to the Bedroom Dimmer, and press the top button four (4) times to identify the device. When
the address appears, click next.
9. Go to the 3-Button Keypad, and press the top button four (4) times in rapid succession to
identify the device. When the address appears, click next.
10. Click next to continue to the next section to define Audio/Video connections.
2.9.1.4 Example: Define the Audio/Video Connections
This section discusses using Control4® Interviewer wizard in Composer Pro to define the audio and
video connections. You set up the software for audio and video connections that directly correspond
to your hardware connections between your devices.
Note: This process follows “Example: Identify the Devices on the Network.”
You are now in the Audio/Video section of Interviewer. In this section you identify any devices and
their connections that carry audio and/or video signals. Using the Smith Home example project (a
Controller project), complete the following steps.
To define audio/video connections:
1. Choose the device(s) to which the specified Controller sends audio and video signals.
Example: The Controller in the Theater Room sends audio and video to the Receiver. Add
Theater > Receiver to the Connected Devices list.
2. Click next.
The Receiver is the only device connected to the Television. Both the DVD player and the
Controller route their audio and video signals through the Receiver to get to the Television.