User guide

Composer Pro User Guide
Copyright © 2012 Control4. All Rights Reserved.
Saved: 1/20/2012 1:31:00 PM
200-00005 Composer Pro
User Guide Part 1
Page 134 of 199
3. Identify which Navigators are included in each room by selecting the Navigator, and then clicking
the double-arrow button.
Example: Add the 3 Button Keypad for the Navigator in the Front Room.
4. Click next.
5. Add the Sensors to the Devices in the Room list.
Example: Add the Doorbell and Motion Sensor to the Front Room.
6. Click next.
7. Add the Motorized devices to the Devices in the Room list.
Example: Add the following: Electronic Gate and Sprinklers.
If you have a Thermostat, add it in Composer Pro after you exit Interviewer. See “Configuring HVAC
Systems.”
You have just completed defining the devices in each room. Click next to continue to the next section
to identify the network connections.
2.9.1.3 Example: Identify the Devices on the Network
This section discusses using Control4® Interviewer wizard in Composer Pro to identify the devices
you've added in the project to the network.
Note: This process follows “Example: Define Devices in Each Room.”