Instruction manual

20
This instruction manual explains the basic instructions for operating this unit. Some DVDs are
produced in a manner that allows for specific or limited operation during playback. Therefore,
this unit may not respond to all operating commands. This is not a defect.
Please refer to the instructions accompanying the specific DVD in question for more information
about the options available on that DVD.
“ ” may appear on the screen during operation. “ ” means that the desired operation is not
permitted by the unit or disc.
Basic DVD Playback
1. Slide the ON/OFF switch to the ON position on both DVD
players A and B.
2. Slide the OPEN latch to open the disc tray.
3. Hold the disc by its edges and carefully place onto the disc
holder with the label side facing the front panel. Gently push
the disc down until you hear a “click”.
4. Close the disc cover. The unit starts playback if the disc does
not have any menus recorded on it. If the disc has one or more
titles recorded on it, a menu screen will appear on the screen.
5. To play a title, press the buttons on the unit or press the / 0-9 / 10+ buttons on
the remote control to highlight the title and then press the ENTER button on the unit or the
remote control to confirm.
• The screen saver will automatically activate after 5 minutes of no activity. Press any
button to exit the screen saver.
• If there is no-activity after 20 minutes, the unit will automatically enter standby mode.
Turning On the DVD Player
1. Slide the ON/OFF switch to ON position on the left
panel to turn the DVD player on.
2. The LOGIK DVD logo (start-up picture) will appear
on the screen and the unit will start loading the disc
automatically (if available).
3. After use, slide the ON/OFF switch to OFF on the left
panel to turn the DVD player off.
Basic Playback
OPEN
VOL-
ENTER
VOL+
SOURCE
Ensure that the screen protection film is removed before use.
L9DUALM12_IB_121109_Michelle.indd 20 09/11/2012 11:05 AM