Instruction Manual

3 - 59
Characters 5,6 - Parameter Number:
These characters should always be “0”.
Characters 7 through 8 - DATA:
These characters should always be “0”.
Characters 9,10- DATA:
01 F–Stop
02 R–Stop
03 Run
04 Enable Master Mode
05 Enable Follower Mode
06 Not in Use
07 Not in Use
08 Not in Use
09 Not in Use
10 Enable Setpoint 1/3
11 Enable Setpoint 2/4
12 Not in Use
13 Not in Use
14 Not in Use
15 Not in Use
Character 11 - Data Format:
This character should always be “0”.
Character 12 - ETX:
Always use the ASCII “ETX” character to terminate the character string.