Instructions / Assembly

The Hex Key is used to tighten the framework together

as you assemble your uDivide™. Make sure the

Glide Strip

is rmly in place to help cushion your Insert Panels.

Fig #3

First locate the Horizontal Bar with one (1) Glide Strip and

slide it into place at the bottom of the two Round Post

slots as shown in Fig #3.

Fig #4

Remember to peel away all protective lm from Insert

Panels before Assembling. Slide Panels down inside the

vertical slots of the Round Posts on top of the Horizontal

Bar. If your congurations include Vertical Bars then insert

the middle Vertical Bar with Glide Strips as shown in Fig #4.

Locking Assembly

Horizontal / Vertical Bar

To install locking assemblies into

the horizontal frame bars, rst

remove the Hex Screw, then place a

Locking Assembly into the end of

the bar and insert the Hex Screw

back into the Locking Assembly

Page 4