Instructions / Assembly

5
Model 7800 / 8800 - PRIN-2245 -0117
Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | www.CwDoor.com
STEP 4 Fixed Glass Panel Installation
Inside
Tub/Shower
3”
Figure 5
A. First assemble the 1” Round Tube Rail (#2). Install the other
Rail Stop (#3), then the Rail/Fixed Panel Clamps (#4) on the
1” Round Tube Rail (#2). Do not over-tighten the Rail/Fixed
Panel Clamps (#4). Attach the second Wall Bracket (#1) to
the other end of the 1” Round Tube Rail (#2).
C. Attach the Glass-to-Wall Clamp (#10) to the Fixed Glass
Panel (#5) (See Figure 4).
B. Attach the assembled Rail/Fixed Panel Clamp (#4) to the
Fixed Panel (#5).
D. Insert Setting Blocks (#12) into the U-Channel (#13), 4” from
each end.
F. Insert assembled Fixed Glass Panel (#5) into U-Channel
(#13). Have pencil ready to mark hole positions.
Figure 6
G. Make all necessary adjustments, ensuring the 1” Round
Tube Rail (#2) is level and the Fixed Glass Panel (#5) is
plumb.
H. Mark the position of both the left and the right Wall
Brackets (#1) drawing around the Wall Brackets (#1) then
mark both Glass-to-Wall Clamp holes (#10) using your
pencil (See Figure 6 and Figure 7).
E. Place U-Channel (#13) on tub/shower curb in desired
location 3” from the inside of tub/shower (see Figure 5).
Figure 7
4
5
10
Figure 4
NOTE: One of the two (2) Rail Stops (#3) and one of the Wall
Brackets (#1) have already been pre-assembled on the 1”
Round Tube Rail (#2). However, you will need to adjust them
later during the installation process.
Figure 8
I. Remove Fixed Glass Panel (#5), and set it out of the way on
protective material.
J. Take one (1) of the Wall Brackets (#1) with the threaded
round mounting screw and place it over the round circle
you drew when marking the Rail height. Mark the holes to
drill on both sides of your tub/shower walls (See Figure 7).
K. Drill holes for Wall Brackets (#1) and Glass-to-Wall Clamp
(#10), and then insert the screw anchors. Mark the
Glass-to-Wall Clamp holes (#10) using your pencil (see
Figure 6 and Figure 7).
L. Fasten the Wall Bracket (#1) male thread to the wall (see
Figure 8).