Instructions / Assembly

4
Model 7800 / 8800 - PRIN-2245 -0117
Contractors Wardrobe
®
, 26121 Avenue Hall, Valencia, CA 91355 | Phone: [phone] Fax: [phone] | www.CwDoor.com
• Phillips Screwdriver
• Level (preferably 18” or larger)
• Electric Drill
• 1/8“ Drill Bit (for fiberglass stall)
• 3/16” Masonry Drill Bit (for tile stall)
• 7/64“ Drill Bit
• 1/4” Carbide Drill Bit
• Fine File
• Miter Box and Hacksaw (with 32 Teeth/Inch Blade)
• Pliers
• Pencil
• Caulking Gun (with tube of Clear Tub/Tile Silicone)
• Tape Measure
• Safety Glasses and Gloves
• Scissors
• Duct Tape
TOOL CHECKLIST:
In addition to parts supplied by Cw
®
you will also need:
STEP 1 Removing Existing Shower Doors
STEP 2 Suggested Configuration
IMPORTANT: If the unit has clear glass it is reversible and can be
installed to the right or left side. The Mystique™ or patterned
glass is not reversible, and the direction of installation is specific
to the configuration purchased. The textured side of the
Mystique™ or patterned tempered glass unit should always be
installed on the outside of the unit.
Ensure that there is sufficient structural support behind the
Shower wall to hold the weight of the Shower Door. If there is
insufficient support, then reinforce the Shower walls with studs
prior to Tub/Shower Enclosure installation.
NOTE: The rail and hardware parts are nested inside a box with
protective foam packaging (Parts #1, #2, #3, #4, #7, #8, #9, #10, and
#16). The Rail Stops (#3) and Rail/Fixed Glass Panel Clamps (#4)
have been pre-assembled on the 1” Round Tube Rail (#2) for your
convenience.
After determining that your newly purchased Tub/Shower
Enclosure is the correct size, remove the existing Tub/Shower
Enclosure and all existing parts of that door assembly. Remove
all screw anchors from the wall. Clean silicone sealant or
Tub/Shower caulking and any other contaminants from
Tub/Shower and wall surfaces.
#13 1 U-Channel
#14 1 Dam Strip
#15 1 Wall Polycarbonate
#16 1 Allen Wrenches
#11 1 Bi-Pass Splash Guard
#12 2 Setting Blocks
STEP 3 Wheel Assembly Installation
Figure 3
Install two (2) Wheel Assemblies (#7)
on the Sliding Door Panel (#6) using
the two (2) top holes. Once they are
installed, carefully place the Sliding
Door Panel (#6) into the tub/shower
enclosure, setting the tempered glass
on protective material and not directly
on a hard surface. Lean the tempered
glass Door Panel against the
tub/shower enclosure wall with the
Wheel Assemblies (#7) facing
outward (See Figure 3).
NOTE: If you ordered a custom unit, your parts may be different
based on what you ordered.
Figure 2
NOTE: Views and directions given in these instructions - left,
right, front, back, etc. - are from outside the enclosure, facing
the tub/shower (see configuration diagram in Figure 2).