Instructions / Assembly

G. With the Header (#1) free from both Wall Jambs
(#3) and the Panels (#5 and #6) hanging in the
Header (#1), you should now be able to lift out
one or both Panels (#5 and #6) from the Guide
(#4) and disengage them from the Header (#1).
H. As an alternative to taking out one Panel at a time
and having to remove the hardware from each
Panel, you might try this: With the Header (#1)
free from both Wall Jambs (#3), slide the Panels
(#5 and #6) to the center. Each person holds the
Header with one hand next to the Panels (#5 and
#6) to keep them from sliding and the other hand
at the end of the Header (#1).
I. With the Panels (#5 and #6) secured so they
won’t slide, lift the Header (#1) with hanging
Panels (#5 and #6) up and out of the shower
enclosure. Carefully lay the Panels (#5 and #6)
on the floor while still in the Header (#1).
J. To re-install the Door Panels (#5 and #6), reverse
the process described above, hanging the Panels
(#5 and #6) in the Header (#1) and re-attach the
Header (#1) onto the Wall Jambs (#3).
8
Thank you for purchasing a Shower Enclosure. If
you like this product, we invite you to visit our website at
www.CwDoor.com for more information about our
extensive line of other Shower Enclosures, Room
Partitions and Loft Dividers, Cabinet Doors, and
Wardrobe Doors. They feature Duratuf
®
Tempered
Safety Glass, Painted Glass, CwShield
™
Protective
Coating and Duraflect
®
Copper-Free Mirror.
#1100 - I01100 - 0614
Optional Door Handle
Position Handle
midway on Door Panel
Inside of
Shower
Installing the Optional Door Handle
Please note that the Door Handle (#25) is not necessary.
This can be used as another handle to enter the
enclosure. Once installed the Door Panels will not
bi-pass one another.
A. Locate the Handle (#25) and the #6 x 3/8″
Screw (#26).
B. Standing on the outside of the enclosure, with
the curved part of the Handle (#25) facing towards
you, position the Handle (#25) midway on the
frame of the Inside Framed Door Panel (#6) (as
measured from the bottom of the Panel), on the
edge nearest the Wall Jamb (#3) near the shower
head. Use a #6 x 3/8″ Screw (#26) to attach the
Handle (#25) to the Side Rail (#7) of the Inside
Framed Door Panel (#6).
WARNING
Make sure not to drill into the Side Rail (#7) before
attaching the screw. Drilling directly into the Side Rail
(#7) could potentially cause the glass Panel to explode.
The screw will safely drill through the Handle (#25) and
into the Side Rail (#7).
Handle
(#25)
Screw
(#26)