Instructions / Assembly

STEP 5 Installing the Panel Locator
A. In order to install the Panel Locator (#13) you
must first determine which wall the shower head
is on. See Figures 4A and 4B.
B. Attach Panel Locator (#13) to the edge of the
Wall Jamb (#3) on the shower head side, as
shown.
STEP 6 Installing the Header
A. Using the Tape Measure, measure the distance
between the left and right wall at the top
(Remember, the width at the bottom of the
enclosure may not be the same as the width of
the top of the enclosure because walls may not
be plumb and square).
B. Locate the Header (#1). Using the Miter Box and
Hacksaw, cut the Header (#1) to the length you
just measured.
C. The Model #1100 comes with a positive snap-lock
feature which eliminates the need for screws to
hold the Header (#1) in place, and help to secure
the Panels (#5 and #6) in Header (#1) in case
there is an earthquake. Position the Header (#1)
over the top of the Wall Jambs (#3). Spread the
Header (#1) sides slightly as you pull it down
firmly onto the Wall Jambs (#3) as it snaps and
locks in place. You should be able to hear and
feel when it solidly locks in place.
STEP 7 Installing the Rollers on
the Panels
IMPORTANT: Enclosures with Obscure or Specialty
glass are installed with the textured surface of the framed
Panels facing out, or to the front. The smooth surface will
face into the shower. This orientation gives you the front
and back of each Panel. Now, locate the Outside Framed
Door Panel (#5). Locate four #8-32 x 3/8” HWH Screws
(#17).
A. Use two #8-32 x 3/8” HWH Screws (#17) to attach
two Rollers (#11) to the top of the Outside Framed
Door Panel (#5) with the Rollers (#11) on the
front surface of the Top Rail (#10). The metal
parts (the Nut side) should be against the frame,
as shown in Figure 5B.
pre-drilled holes in the left Wall Jamb (#3L). Set
the Wall Jamb (#3L) aside for the moment.
C. Using either a 1/8” Drill Bit (for a fiberglass
enclosure) or a 3/16” Masonry Drill Bit (for tile) drill
three holes where you made
the marks. If installing in a
tiled enclosure, gently tap
a Screw Anchor (#21) into
each hole. DO NOT use the
Screw Anchors (#21) for a
fiberglass enclosure.
D. Place the Wall Jamb (#3L)
back over the Curb (#2) and
against the wall and secure
with a single #8 x 1-1/2” PH
SMS Screw (#20) and one
Wall Jamb Bumper (#12)
in the TOP hole only, at this
time.
E. Repeat Steps 4A through 4C for the right Wall
Jamb (#3R).
F. Remove the Duct Tape after Silicone dries.
G. Use two #8 x 1-1/2” FH SMS Screws (#19) to
secure the middle of the Wall Jamb (#3).
H. Use two #8 x 1-1/2” PH SMS Screws (#20) to
secure the Wall Jamb Bumpers (#12) in the bot-
tom hole of the left and right Wall Jambs (#3) to
completely secure the Wall Jambs (#3).
Figure 4B
Shower head
and controls
left side
3L
12
20
3R
13
20
12
4
Figure 4C
19
19
20
12
20
12
#1100 - I01100 - 0614