Instructions / Assembly

B. Center the Curb (#2) on the sill/dam. In some
installations, you may prefer to position the Curb
(#2) forward or back of center. For example, by
moving the Curb (#2) forward, you will slightly
increase the depth within the shower area (See
Figure 2).
C. Locate Curb (#2). Remove the Panel Glide Strip
(#16) from the Curb (#2). See IPB Drawing.
D. Using the measurement from Step 3A, cut the
Curb (#2) to this length. Use the Miter Box and
Hacksaw to make a straight cut.
E. Using the Wire Cutters, cut the Panel Glide Strip
(#16) 3/8” shorter than the Curb (#2). Re-install
the Panel Glide Strip (#16) into the Curb (#2)
and position it (center it) so that the ends of
Panel Glide Strip (#16) are evenly spaced at
each end of the Curb (#2).
F. Cut two pieces of Duct Tape 12” long. Next,
use the Caulking Gun to apply a thick bead of
Silicone sealant (approximately 3/8” in diameter)
to the bottom surface of the Curb (#2) along its
entire length. Place the Curb (#2) on the shower
sill, in the position you determined in Step 3B.
Use the two strips of Duct Tape to temporarily
hold the Curb (#2) in place, but DO NOT place
the tape within 2” of the wall. In other words, the
distance (gap) between the wall and the tape
should be 2” or more away from the walls so that
the tape will not be in your way when you install
the Wall Jambs (#3) (See Figure 2).
NOTE: The tape will help provide a positive seal to the
shower sill while holding the Curb (#2) in place for
the following steps.
STEP 4 Installing the Wall Jambs
NOTE: The Model #1100 comes with two Wall Jambs
(#3). One is notched for the left wall, the other is
notched for the right wall (as you face the enclo-
sure from the outside). If you look at the bottom
end of each Wall Jamb (#3), on the back surface
you will see that each is clearly stamped “L” for
left, “R” for right.
A. Locate the left Wall Jamb (#3L) marked with an
“L”. If your shower has curved corners, use a
File to round off and shape the bottom ends of the
Wall Jambs (#3) to fit the rounded corners of the
shower.
B. Place the left Wall Jamb (#3L) against the left wall
and slip/snap the bottom of the Wall Jamb (#3L)
over the Curb (#2). Use a Level held against the
side of the Wall Jamb (#3L) to align it vertically
straight up and down as shown in Figure 3. Use
a Pencil to mark the position of each of the three
Figure 3
Top of
Wall Jamb
If your enclosure has
rounded corners,
use a file to shape the
Curb to fit
Curb
Shower head
and controls
right side
3L
12
20
3R
13
20
12
3
Figure 2
INSIDE
TUB
Duct Tape
Silicone
Panel Glide Strip
Curb
OUTSIDE
TUB
19
20
12
20
12
19
Level
#1100 - I01100 - 0614
Figure 4A