ContourHD Wearable Camcorder Product Guide
Quick Start About the Camera d b h i c j a Power Button HD b Battery Status g SD c Record Button a d Rotating Lens k e Record Status f Memory Status g HD/SD Switch l e f h USB i Charge Indicator or j Battery Latch k Battery Slot l MicroSD card 1
Getting Ready Power Up s Open the back door. s Push power button. s Camera beeps and lights turn off. s You are ready to record. s Insert battery with (+) aligned and close latch. s Align back door slightly above camera and slide down until it locks in. 2 Note: Power up with record switch forward to enable silent mode.
Record s Start: slide switch forward. s Stop: slide switch back. s Congrats, your first video! stop start Share s Install Easy Edit Software directly from MicroSD card provided or download at: www.VholdR.com/support/ software. s Connect camera to computer with USB cable. s Set date and time on your camera using the Easy Edit Software s Then import, clip and share your videos… Note: HD is beautiful but some computers cannot play smooth HD video. Visit www.vholdr.
Memory s 2GB microdSD card included. Accepts up to 16GB microSD (SDHC Compatible). Note: Always power off before ejecting card. s Use switch under back door to select video resolution. HD: Amazing clarity 1280 x 720 at 30fps 30 min avg record time/GB Wide angle lens: 135 deg. SD: Fast Action 848 x 480 at 60 fps 60 min record time/GB Wide angle lens: 110 deg. Power Recharge s Connect to computer with USB cable. s Red light indicates charging. s Charge complete when camera beeps and red light turns off.
Status Press power button to check status. s Memory / Battery Available Green > 80% Yellow 20-80% Red < 20% s Record Status Green = ready Red = recording Flashing = memory full or corrupt Error Conditions s s s s s Time invalid: Memory/battery flash red at power on. Memory full: (3) beeps, recording stops. Memory corrupt: (3) beeps, shuts off. Battery dead: lights flash, beeps, shut off. No beeps: camera in silent mode.
Flat Surface Mount s Unhook leash on base and loop through camera. s Slide camera onto rails until completely forward. s Adhere mount to flat surface (top or side of helmet recommended). s Hold base, pull camera away, rotate to align, and press into mount to reattach.
Goggle Mount s Slide camera on rails until completely forward. s Press thumb on large tab (top of mount) and pull camera away. s Slide goggle strap into base. s Align vertical angle of camera. s Snap rails back into mount over strap.
Align • Press power button to activate lasers. • Aim at your hand, a wall, or other object. • Rotate lens to align lasers horizontally. • Remove and reorient mount rails to adjust mount angle. Aim a little high for the best shot.
Tips & Troubleshooting We want to help you have a great ContourHD1080p experience so please contact us with any questions you have. Hours: Monday – Friday (9am to 6pm PST) Toll Free: 866.397.6920 (USA) International: 206.792.5226 Email: support@vholdr.com Web: www.vholdr.
Cautions and Warranty This Important Product Information Guide contains regulatory, safety, handling, disposal and recycling information, as well as the 180-day limited warranty for your ContourHD Camera. Read all safety information below and operating instructions before using ContourHD Camera to avoid injury. For detailed operating instructions and the latest Important Product Information Guide, go to: www.vholdr.com/support.
ContourHD uses a rechargeable lithium-ion, 3.7V, 1050mAh battery. Do not use batteries other than those specifically designed for the ContourHD. Use of any other battery may invalidate the warranty provided by Twenty20, Inc. and may present a risk of fire or explosion. To charge, only use the ContourHD USB Cable with a high-power USB port on a computer or other device that is compliant with the USB 2.0 or 1.1 standards, or the ContourHD wall, car, or battery charger.
FCC Information ContourHD Wearable Camcorder Model: 1200 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: This device may not cause harmful interference, and This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modification to this unit not expressly approved by party responsible for compliance could void the user’s authority to operate the equipment.
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: s Reorient or relocate the receiving antenna. s Increase separation between equipment and receiver. s Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. s Consult the dealer or an experienced radio/TV technician for help.
Laser notice ContourHD is a Class II laser device. Laser radiation is emitted from the ContourHD when using the lasers for alignment. Please use caution and do not stare directly into the beam or point at others. Repairing or modifying Never attempt to repair or modify ContourHD Camera yourself. Disassembling ContourHD Camera, including the removal of external screws, may cause damage that is not covered under the warranty.
TWENTY20, INC. LIMITED WARRANTY Twenty20, Inc. (“Manufacturer”) warrants to the original end user (“Purchaser”) that for the 180 days (“Warranty Period”), the ContourHD Wearable Camcorder (excluding any third party software) and accessories (“Product”) will be free from defects in materials and workmanship when properly installed and used for its intended purpose and in its intended operating environment.
to Manufacturer for service), and assumes no liability for such loss. Purchaser assumes all liability, and as such releases Manufacturer from any liability, for any accident, injury, damage, death, loss, illegal activity or any other claim that may occur resulting from or during use of the Product, whether or not such use is foreseeable by Manufacturer. ALL IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE DURATION OF THE APPLICABLE EXPRESS WARRANTY.
TO THE EXTENT NOT PROHIBITED BY LAW, IN NO EVENT WILL MANUFACTURER BE LIABLE FOR ANY LOST DATA, REVENUE OR PROFIT, OR FOR SPECIAL, INDIRECT, CONSEQUENTIAL, INCIDENTAL OR PUNITIVE DAMAGES, HOWEVER CAUSED REGARDLESS OF THE THEORY OF LIABILITY, ARISING OUT OF OR RELATED TO THE USE OF OR INABILITY TO USE THE PRODUCT, EVEN IF MANUFACTURER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. IN NO EVENT WILL MANUFACTURER’S LIABILITY EXCEED THE AMOUNT PAID BY PURCHASER FOR THE PRODUCT.
All trademarks and registered trademarks mentioned herein are recognized as the property of their respective holders. ContourHD is a product of Twenty20 Corporation in Seattle Washington www.vholdr.com ©2009 Twenty20 Corporation. All rights reserved.
