User manual

13
12
Contour+2 User Manual
SETTING UPSETTING UP
Adhesive Mounts
Clean and dry the mounting surface before applying an adhesive mount. We
suggest cleaning the surface with a small amount of alcohol and applying the
mount at room temperature. Let the adhesive cure for 24 hours before use.
When mounting the camera on your helmet or goggles, you may
discover that you look down more than you thought. It may take a few
practice videos to find the right alignment.
Mounting Your Camera
Getting the best shot depends only on your creativity. Contour offers a
wide range of mounts that let you put the camera just about anywhere,
so be creative.
Remember that your Contour+2 has a wide-angle lens and objects that
are far away will seem smaller than you expect in your videos.
Alignment
Your Contour+2 has a Laser Line that helps ensure you have the horizon
properly aligned in your videos. To use, activate the Laser Line by
pressing the Status Button; place your hand in front of the Laser Line or
aim it on to a flat surface a few feet in front of you and rotate the lens (up
to 270
°
) until the Laser Line is horizontal.
Use the Contour Connect mobile app to see a live preview of your shot via
Bluetooth connection on your Android or iOS device.
Waterproof Case
+ Press firmly to position your camera at the back of the case and close
the Cover Latch to lock tight.
+ Press the Status Button on the back of the case to activate the camera's
Status Button.
+ Start and stop recording with top Record Slider.
+ When using the TRail mounts, engage the TRail Lock on the same side
as the mount for extra security.
Waterproof Case Maintenance & Storage
Inspect the rubber seal for damage prior to each use. Keep the rubber seal
free of dirt and do not use sharp objects to remove the rubber seal. Store
your Waterproof Case unlatched to avoid damage to the rubber seal, and
never store it in direct sunlight. After salt-water use, soak the case in fresh
water for up to an 1 hour.