User manual

9
8
Contour+2 User Manual
SETTING UPSETTING UP
Camera Status
Press and release the Status Button on the back of your camera to activate
the Laser Line, and display status of Battery, Memory, and GPS. The
camera will power off after 15 seconds or if you press the
Status Button again.
Battery Status LED
Green: 50% or more.
Yellow: 20 to 50%.
Red: 20% or less.
Red Flashing: The
battery is almost fully
discharged.
No LED: The battery is
fully drained and must
be charged.
Memory Status LED
Green: 50% or more.
Yellow: 20 to 50%.
Red: 20% or less.
Red Flashing and
continuous beeps: The
microSD Card cannot
be read by the camera
because the card is full,
missing, or not
properly formatted.
GPS Status LED
Green Flashing:
Searching for satellites.
Green Solid: GPS Position
Fix obtained, and data can
be recorded to video.
No LED: The GPS system
is deactivated.
Formatting The microSD Card
Format the microSD Card prior to recording so your camera is able to
properly read and write to it. Caution: formatting the card will erase
everything on it.
Check that the Record Slider is in the off position. Open the back of your
camera then press and hold the Format Button until the camera beeps
(three to five seconds). The microSD Card LED will flash while the card is
formatting and then turn solid green when the format is complete.
Do not attempt to
format the microSD
Card if the battery is
not charged. Also do
not remove the battery
when formatting the
microSD Card.
The Contour+2 is compatible with:
+ SDSC (standard capacity) microSD Cards up to a capacity of 2GB.
+ SDHC (high capacity) class 4, 6, or 10 microSD Cards up to a
maximum capacity of 32GB.