Owners manual

restrictions set forth in subparagraph (c)(1)(ii) of The Rights in Technical Data and
Computer Software clause at DFAR S 252.227-7013 or subparagraphs (c)(1) and (2) of
the Commercial Computer Software Restricted Rights at 48 C FR 52.227-19, as
applicable. Manufacturer is Contour Design, Inc., 10 Industrial Dr. Windham, NH 03087
USA.
European Community Provisions - If this Software is used within a country of the
European Community, nothing in this Agreement shall be construed as restricting any
rights available under the European Community Software Directive, O.J. Eur. Comm.
(No. L. 122) 42 (1991)
Questions. If you have any questions concerning this Agreement, or if you desire to
contact Contour Design for any reason, please write: Contour Design, Inc., Customer
Sales and Service, 10 Industrial Dr. Windham, NH 03087 USA.
REGULATORY INFORMATION
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: This device cannot cause harmful interference; this device must accept
any interference received, including interference that can cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, can cause harmful interference with radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
This product complies with part 15 of the U.S. Federal Communications Commission (FCC) Rules
and meets all requirements for Class B digital apparatus of the Canadian Interference-Causing
Equipment Regulations.
Contour Perfit Mouse Control Panel
12