Owner`s manual

Operating Instructions for i-Fill

™

System (Auto Fill)

(Auto Fill is a Factory Installed Option)

Step #1) LIFT AND TURN chrome handle for Hot/Cold water valve (6) located in front of spa.

Make sure drain Pop-Up (13) is in the up position allowing water to drain from basin.

Step #2) Press “i-Fill-Auto” button to begin water flow. If spa has optional drain pump, one must also

start the drain pump by pressing “Pump” button (4). When water reaches desired temperature; turn

Drain Handle (5) to lower Pop-Up (13). Water flow will automatically stop and jet will start running

when water level reaches preset level (Jet has a built-in one (1) hour timer). Jet may be shut off man-

ually by pressing Jet Icon located on i-Fill button. Press button a second time to restart jet (See pic-

ture below). To add additional water; press Faucet Icon located on i-Fill button (See picture below).

Press button a second time to stop water flow. There is an audible tone as additional water is being

added to basin.

VERY IMPORTANT (Applies ONLY to i-Fill Equipped Spas)

In order to prevent hot and cold water from mixing inside an open water valve; once water stops flow-

ing close valve handle (6) by gently pushing it to the down position. Furthermore, Neoperl check

valves have been installed on the brass hot and cold water inlets located in the back of the spa. This

will prevent any cross connection of hot and cold water.

Adjusting Sensor Delay Time Setting

As a result of water pressure and/or basin size, it may be necessary to change the amount of time

water flows after reaching the sensors located on the jet body. If this is the case, please note the fol-

lowing:

A green colored control box is located underneath the left curved plastic shroud (When facing spa).

Removing this curved shroud is quite easy. (Note: Because of space constraints, the control box is

mounted upside down.)

On the side of the control box is a blue LED light. Next to it is a blue circle control. Utilizing a small

screwdriver, GENTLY turn the arrow inside the circle to read from 5 seconds to 55 seconds. By turn-

ing the arrow and changing the time delay; more or less water will fill the basin. For safety purposes,

there is a four (4) minute water flow timer built into the control box.

Pedicure Chairs from

Continuum

Footspas

i-Fill Button

(Auto Fill ON/OFF)

Faucet Icon

(Press for Additional Water)

Jet Icon

(ON/OFF)