Owners Manual

6
BOTTLE, KEG & BACK BAR COOLERS, GLASS & PLATE CHILLERS
OPERATIONS MANUAL
DOOR ADJUSTMENT (KC & BBC Models)
All doors are aligned at the factory, however vibration during
transit may cause them to shift and realignment may be neces-
sary. If the door(s) require realignment, proceed as follows
(see Figure 4):
1. Open the door (90°) and loosen, but do not remove the
mounting screws securing the top and bottom hinge
brackets to the cabinet.
2. Adjust the door to desired position by hand or by tapping
on the edge with a rubber mallet.
3. Securely tighten all mounting screws.
4. Check door alignment; repeat adjustment if necessary.
(WHEN EQUIPPED)
BACK BAR DOOR ASSEMBLY
(WHEN EQUIPPED)
LOCK TONGUE
GASKET
BUSHING
HANDLE
SCREW
LOCK
SCREW
BRACKET
SCREW
HINGE
BUSHING
HINGE
BRACKET
FIGURE 5: KC/BBC Door Components
FIGURE 4: KC/BBC Hinge Adjustment
LEFT-HAND
HINGED DOOR
TOP HINGE
BRACKET
MOUNTING
SCREW
BUSHING
HINGE
PIN
KC - BBC DOOR HINGE
INITIAL CLEANING PROCEDURE
Prior to start-up and before placing any product inside of your
new model, the interior of the cabinet should be thoroughly
cleaned. Remove the protective film (which is clear on some
models) from all interior sides, bottom and other internal metal
panels, by working the corner loose and slowly pulling the film
back. Washing with a mild soap and warm water solution is
recommended for cleaning the aluminum and stainless steel
surfaces of your cabinet. This should be followed by cleaning
with a baking soda solution (three (3) tablespoons of baking
soda to each quart of warm water). Wipe down thoroughly with
a damp cloth or sponge that has been soaked in clean water and
wrung out thoroughly, and dry with a clean, soft cloth.
IMPORTANT NOTE: Never use harsh detergents, clean-
ers, scouring powders or chemicals when cleaning your
model. Failure to dry the interior surfaces after cleaning
may result in a streaking or staining of the metal.
Complete cleaning procedures and precautions are listed in the
(“Periodic Cleaning Procedure” under “Maintenance”).
START-UP PROCEDURE
ELECTRICAL CONNECTIONS
To insure proper operation, your new model must be connected
to an individual circuit that can supply the full voltage as stated
on the cabinet serial data plate. For correct voltage, power draw,
and wire accommodations, check the data on the serial data
plate located on the inner right wall of your new model. Verify
that this information exactly matches the electrical character-
istics at the installation location. An electrical wiring diagram,
located on the inside compressor compartment rear, next to
the electrical console box, should also be consulted during
connection. For reference, a copy of each electrical wiring dia-
gram is located towards the back of this manual (see “Wiring
Diagrams” section).
Refrigeration compressors are designed to operate within
+/-10% of the rated voltage indicated on the cabinet serial
plate. Excessively high or low supply power can burnout the
compressor. This can be easily detected and will void the fac-
tory warranty. Full voltage at the correct rating, on a separate,
designated circuit, not affected by the operation of other electri-
cal appliances, must be available to the refrigeration unit at all
times. Extension cords should never be used on commercial
equipment, as they can overheat and/or result in low voltage.