Continental Install

7
REPLACING FILTERS
When the Air Filter and UV Lamp service lights on the Control Panel (Fig.1) turn red,
the filters and UV lamp should be replaced.
1. Turn the unit off and unplug the power cord
from the electrical outlet.
2. Rest the air purifier on its back to access the
bottom of the unit (Fig. 4).
3. Press in the locking clips at each end of the
front grille.
4. Lift the bottom of grille and slide it out from
the top of the unit (Fig. 5).
5. Pull out the two filters individually and discard
them.
6. Install the new white HEPA filter (labeled second
stage) in lower slot, with its white layer facing
upward (Fig. 6).
7. Install the new pre-filter (labeled first stage) in
the remaining slot, with its white or green side
facing upward.
8. Replace grille by sliding upper end into grille
slot, and snap the bottom into place so that it
locks.
9. Reset the filter replacement timer by lightly
pressing the Air Filter Reset button on the
Control Panel with a pin or similar object.
The Air Filter light will turn green, indicating
the timer has been reset.
Restore the CX1000 to normal operation as follows:
1. Set the unit in its normal operating position.
2. Plug the power cord into the wall outlet.
3. Press the Power button and reset the fan speed
to resume normal operation. See page (4).
Fig. 4
Fig. 5
Fig. 6