Continental Install

OPERATION

1. Press the Power button on the Control Panel to turn on the CX1000. Lights on

the panel will illuminate and the UVC lamp will turn on (Fig. 1).

2. Look into the air outlet at the top of the CX1000 to confirm that the UVC lamp is

operating with a faint blue glow.

3. Set the fan speed to the correct room size.

Room area (length x width) is listed in both square feet and square meters at either

side of the green bar light panel underneath Room Size / Fan Speed. Determine

the area of the room. Press the Fan Speed button (Fig. 1) until the green bar light

reaches the corresponding size of the room.

NOTE: The Air Quality light may turn red on startup until the surrounding air

quality improves. When the Air Quality light is red, the airflow is automatically

increased by two power levels. The lowest fan speed cannot be reached until the

Air Quality light turns orange and then green as air quality reaches a safe level.

4. Press the Sleep Mode button (Fig. 1), if desired, to reduce fan noise. A green LED

light to the right of the button will illuminate. Since there is no movement in a

room while sleeping, air purification requirements are reduced. Sleep Mode will

reduce fan speed to a minimum, while maintaining constant airflow. Press the

Sleep Mode button again to resume normal operation.

AIR QUALITY MONITORING

The VOC Sensor continually monitors the air quality in the room, as follows:

• Green light - Good air quality

• Orange light - Poor air quality

• Red light - Bad air quality

Airflow is automatically increased by two fan speeds when the Air Quality light turns

red; it will return to the preset fan speed when the light turns orange. It is normal for

the light to turn red during periods of house cleaning, painting, or cooking meals.

Fig. 1 - Control Panel