User's Guide

Installation/User Guide
16
Internal
7.4. Cable Management
 Strain relieve and support all cable installations.
 Avoid sharp bends and tight radius installations of cables.
 Avoid moving components (for example, doors, steering shafts, handles, fans, etc.).
 Provide enough cable slack to allow for servicing of equipment (adequate service loop)
 Avoid routing cables through doors, windows, and other pinch points.
 Avoid routing cables in high personnel traffic areas.
 Avoid routing antenna cables near radio and PA equipment.
7.5. General Housekeeping
 Capture all drill chips during drilling operations. Do not allow drill chips to fall onto electrical
equipment, furnishings, heating ducts, etc. Magnets, sticky tape, vacuums, physical barriers, etc.
may all be used to accomplish this task.
 Remove excess sealant. Sealant should be debris and contaminant free (for example, no drill
chips), consistent, and uniform in appearance.
 Clip excess wire tie protrusions.