Owner's Manual

L'appareil est installé dans le véhicule à une distance supérieure à 20 cm des

passagers.

This equipment complies with the RSS-102 limits set forth for an uncontrolled

environment.

Cet équipement est conforme a RSS-102 limites énoncées pour un

environnement non contrôlé.

Continental Automotive GmbH

1 Label Information Canada/USA

Continental

Model: FBD5

HVIN: FBD5MY23

FCC ID:KR5FBD5MY23

IC:7812D-FBD5MY23

CAN

RSS-Gen/CNR-Gen

2 Owner Manual

2.1 Owner Manual Canada

IC:7812

D-FBD5MY23

This device contains licence-exempt transmitter(s)/receiver(s) that comply with

Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes

aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le

fonctionnement est soumis aux deux conditions suivantes:

The product with the product identification (FCC ID:KR5FBD5MY23 and IC:7812D-FBD5MY23)

is factory installed inside transportation vehicles. Due to the fact that the device itself does not

have any customer controls, the functional description of the entire system will be included in the

individual owner’s manual of the vehicle.

PAGE 1
Continental Automotive GmbH 1 Label Information Canada/USA Continental Model: FBD5 HVIN: FBD5MY23 FCC ID:KR5FBD5MY23 IC:7812D-FBD5MY23 CAN RSS-Gen/CNR-Gen 2 Owner Manual The product with the product identification (FCC ID:KR5FBD5MY23 and IC:7812D-FBD5MY23) is factory installed inside transportation vehicles. Due to the fact that the device itself does not have any customer controls, the functional description of the entire system will be included in the individual owner’s manual of the vehicle. 2.
PAGE 2
Continental Automotive GmbH 2.2 Owner Manual USA FCC ID:KR5FBD5MY23 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.