User's Guide
BL28EU-RD1 OEM Manual and User Guide
4
• « Le présent émetteur radio (ID: LHJ-BL28EURD1; IC: 2807E-BL28EURD1) a été approuvé par
Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain
admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur
au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.»
5 Instructions to OEMs:
Continental must instruct the automotive OEM and provide them to include the following
information into the car user’s manual (i.e. for the DCM):
1. End-users must be provided with transmitter/antenna installation requirements and operating
conditions for satisfying RF exposure compliance:
2. A separate section should clearly state “FCC RF Exposure requirements:”
3. Required operating conditions for end users.
4. The antenna used with this device must be installed to provide a separation distance of at least
20cm from all persons, and must not transmit simultaneously with any other transmitter, except in
accordance with FCC multi-transmitter product procedures.
5. The Maximum ERP/EIRP and maximum antenna gain required for compliance with Parts 15 and
27.
6. Clear instructions describing the other party’s responsibility to obtain station licensing.
6 Layout and Routing Recommendations
6.1 Module Specific
The pad spacing of 1mm should allow the placement of a 600m finished VIA between pads, while
maintaining a 200um Via- to-trace or Via-pad spacing, to facilitate the breakout of inner row signals. The
1mm spacing is also large enough to route two 200m (8 mil) traces between pads.
Figure 6-1 Vias placed between Pads