Datasheet

Contelec AG
Portstrasse 38
CH-2503 Biel/Bienne
Phone [phone]
Telefax [phone]
[e-mail]
A company of the Siedle-Group
Errors and omissions excepted. Subject to
change without notice. / State: 13.07.11
Vert-X 31E 24V / 4 - 20mA
Ordering code
* Switch outputs
Please define number
(max. 127), position and width
of the pulses.
Vert-X 3 1 E 6 7 3 6 1 5 1 4 0 2
Electrical angle
36 Standard Electrical angle 360°
xx Optional 03 to 35; Declaration in 10° steps
99 Optional Special angle
Sensor principle
7 MH-C
8 MH-C2
Mechanical version
31E5 Standard Magnetic actuator type 5
31E6 Standard Magnetic actuator type 6
31E7 Optional Magnetic acutator type 7
31E9 Optional Special magnetic actuator
Output characteristics
Positive gradient CW Standard 1
Positive gradient CCW Optional 2
Positive gradient CW with 1 switch output* Optional A
Positive gradient CCW with 1 switch output* Optional B
Positive gradient CW with 2 switch outputs* Optional C
Positive gradient CCW with 2 switch outputs* Optional D
Sense of rotation settable Optional E
Zero point & sense of rotation settable Optional F
Middle point & sense of rotation settable Optional G
Start + end point & sense of rotation settable Optional H
Programmable with Vert-X EasyAdapt Optional P
Output signal
4mA ... 20mA Standard 5
Power supply voltage
24VDC Standard 1
MH-C MH-C2
Custom magnetic actuator X X
Custom cable X X
Sample rate in fast mode X X
Switch functions TTL (max. 2) - X
Special characteristic curve - X
Special electrical angle within 30° to 360° (ex factory) X X
Electrical angle programmable (Software) - X
Start & end point settable (Additional wires) - X
Sense of rotation CW/CCW settable / programmable (Additional wires or Software) - X
Index point settable / programmable (Additional wires or Software) - X
Electrical connection
4 Standard Cable 3pole
6 Optional Cable 6pole
9 Optional Special cable ; Special wires
Length of cable
02 Standard 1.0m
06 Optional 3.0m
10 Optional 5.0m
99 Optional Special length
Options (on request)
Mounting hole
a Standard Through-hole ø 4.4mm
b Optional Through-hole ø 4.4mm with counterbore ø 7.4mm
a