Cut Sheet

Aluminum Mounting Channel*
Provides excellent heat sinking and protection to the
LEDs while ensuring a clean, straight run.
No mounting clips are availalble for the Ceiling
Edge Mount Mounting Channel.
Mount the channel by drilling holes through
channel and mounting surface and screwing
into place.
No mounting clips are availalble for the Toe Kick
Mounting Channel.
Mount the channel by using construction
adhesive or 3M™ VHB™ tape.
No end caps are availalble for the Ceiling Edge
Mount Mounting Channel.
Catalog No.
Type
Project
3/8"
1-1/4"
1-1/4"
9/16"
3/8"
2/3"
3-1/2"
TL Tapelight Series
Mounting Accessories
TLACKE2 - Toe Kick End
Caps, Grey
TLACKE2-B - Toe Kick End
Caps, Black
TLACKE2-P - Toe Kick End
Caps, White
*Outdoor/Wet listed Tapelight is not compatible with channel end caps or diffusion lenses, except when using the Deep Standard Channel.
www.contechlighting.com1-847-559-5500 RecyclePlease
All specifications subject to change without notice.
TLACE6 - 6' Ceiling Edge Mount
Channel, Aluminum
TLACE6-B - 6' Ceiling Edge Mount
Channel, Black
TLACE6-P - 6' Ceiling Edge Mount
Channel, White
TLACK6 - 6' Toe Kick Channel,
Aluminum
TLACK6-B - 6' Toe Kick Channel,
Black
TLACK6-P - 6' Toe Kick Channel,
White
Wet Listed Tapelight Silicone Sealant
Included with wet listed Tapelight kit. For securing end
caps to end of tapelight to create a water-tight seal.
TLAOSG
Wet Listed Tapelight End Caps
Included with wet listed Tapelight kit. Use with silicone
sealant to create a water tight seal after tape is cut. Set of
two (2) end caps.
TLAOEC2
Wet Listed Tapelight Mounting Clips
Included with wet listed Tapelight kit. Four (4) mounting
clips and eight (8) Philips head screws per package. 24"
Between clips is recommended for most applications.
TLAOMC4
Acrylic Diffusion Lens
For use with mounting channel. Provides extra protection
for the LEDs as well as diffusion to reduce glare. 6' L. Wet
listed Tapelight is not compatible with channel end caps or
diffusion lenses.
TLALC6 - Clear Lens
TLALF6 - Frosted Lens
TLALCD6 - Double Wide Clear Lens
TLALFD6 - Double Wide Frosted Lens
Channel Mounting Clips
Four (4) Mounting clips and four (4) Philips head
screws per package. 24" Between clips recom-
mended for most applications. Stainless Steel.
Channel End Caps
Creates a clean finish to the mounting channel. Set
of two (2) end caps; one open, one closed. ABS
Plastic.
TLTMNTACC_V1903
1/4" 1/4"
9/16"
1"
TLAL_6 TLAL_D6