User's Manual

5. Setup and Status Display
NZ2WL - xxx
47
■
Community Name
Enter the SNMP authentication string. The SNMP authentication string serves as a password to access
this product using SNMP. Programs use this community name to access MIB of this product.
*1
Enter a string of up to 32 alphanumeric characters. The community name is case sensitive.
Factory default setting
:
public
*1 Management Information Base: complies with RFC1213 and RFC1493
■
Access Right
Set the access right for the community. Select “Read/Write” or “Read Only”.
Factory default setting
:
Read / Write
■
Trap IP Address
Trap is the function to notify a user of a change made within the SNMP agent system. The trap function
can be enabled by specifying the IP address of the destination user. The SNMP manager having the IP
address specified here can manage trap information of this product.
If the network contains more than one AP, it is advisable to register the same IP address so that all the
APs can be managed on one machine. If the network contains more than one wireless terminal, it is
advisable to register the same IP address so that all the wireless terminals can be managed on one
machine. Up to three destinations IPs can be registered.
Factory default setting
:
0.0.0.0
■
sysContact
Enter contact information of the administrator of this product. An example is the name and telephone
number of the network administrator. The string can be up to 32 alphanumeric characters.
Factory default setting
:
(No input)
■
sysLocation
Specify the physical location of this product. An example is “Administration Division, 2F”. The string
can be up to 32 alphanumeric characters.
Factory default setting
:
(No input)
■
sysName
Specify the device name of this product under SNMP. Enter a string of up to 32 alphanumeric
characters. The sysName is case sensitive.
Factory default setting
:
(No input)
■
Trap
When the trap function is enabled, a trap is transmitted when the Ethernet or wireless LAN link status
changes (goes down). This can be set separately between Ethernet and wireless LAN.
Factory default setting
:
Ethernet … Disable
Wireless LAN … Disable