User's Manual

5. Setup and Status Display
44
NZ2WL - xxx
■
Network Time
Enabling the network time function can synchronize the access point time with the network time.
To enable this function, set the IP address and time zone of a network time server on the network.
(Example
:
For use in Japan, enter “+09
:
00” (meaning UTC + 9 hours) as the Japan standard time is
nine hours ahead of Universal Time Coordinated (UTC).)
Factory default setting
:
Function …Disable
IP Address … 0.0.0.0
Time Zone … +09
:
00
■
Access Control
Set the access control for this product. Disabling TELNET, FTP, WEB server function rejects the
connection to each server. Note that if disabling all the settings, the product cannot be accessed for
setup.
Enabling specification of administrator IP, you can specify the IP address to connect to TELNET, FTP,
WEB. Up to two administrator IP addresses can be registered in “Administrator IP address 1” and
“Administrator IP address 2”.
When using this function, you need to enable server functions such as TELNET. Note that if only
disabled IP addresses are registered, the connection to the product using the TELNET, FTP, and WEB
cannot be made.
When the "Wireless Access" is set to "Disable", the connection from a wirelessly connected station to
the product using the TELNET, FTP and WEB is rejected. When the setting is "Enable", connections
from a wirelessly connected station are permitted.
Factory default setting
:
TELNET / FTP / WEB Server … Enable
Administrator IP Address … Disable
Administrator IP Address 1
-
2 … 0.0.0.0
Wireless Access … Enable
■
Network Delay Time (s)
Specify the maximum delay time acceptable to the network.
When an access point communicates with the server or another access point, a communication time
-
out
may occur if an intermediary line is slow in communication speed. If this is the case, increase the
network delay time to prevent a time
-
out from occurring.
Enter a value between 0 and 15.
Normally, you do not have to change the default setting.
Factory default setting
:
0 (seconds)
■
Encryption Config File
When this is “Enable”, the setup files (CONFIG) are encrypted and saved to the internal memory when
the settings are saved.
Whether setup file encryption is “Disable” or “Enable”, both encrypted and unencrypted setup files can
be used when those files are written to this product by file transfer.
The password set in this product (up to 31 alphanumeric characters) is used as the password for the
encryption.
Factory default setting
:
Disable