User's Manual

5. Setup and Status Display
42
NZ2WL - xxx
◆IEEE802.1X
■
IEEE802.1X
Set this item to “Enable” to enable the function of IEEE802.1X.
When the IEEE 802.1X function is "Enable" and WPA/WPA2/WPA-AUTO is not used, be sure to
select "WEP" for the wireless LAN security setting to enable key exchange.
This function is not available when the unit type is "Station", so select "Disable".
Factory default setting
:
Disable
■
MAC Address Authentication Function
To enable the MAC address authentication function, set it to "Enable".
Factory default setting
:
Disable
■
Reauthentication Interval (minutes)
Specify the interval at which to perform reauthentication. Specify a value between 2 and 4320
(minutes).
Factory default setting
:
60 (minutes)
■
WPA Reauthentication
Specify whether to periodically perform RADIUS server reauthentication when "WPA", "WPA2", or
"WPA-AUTO" is selected for "WPA Function".
When this is "Enable", reauthentication is performed at the time set in "WPA Reauthentication Interval
(minutes)".
Factory default setting
:
Disable
■
WPA Reauthentication Interval (minutes)
When "WPA Reauthentication" is enabled, set the interval in minutes at which to perform RADIUS
server reauthentication. Specify a value between 2 and 4320 (minutes).
Factory default setting
:
1440 (minutes)
■
(RADIUS server) IP address
Enter the IP address of the RADIUS server.
Factory default setting
:
0.0.0.0
■
(RADIUS server) Port number
Enter the port number used for communication with the RADIUS server.
Factory default setting
:
1812
■
(RADIUS server) ESSID
When switching to the RADIUS server specified in "IP address" above, the ESSID of the access point
changes to the ESSID set here. Set this item only when using this function. Leave this item blank when
you do not need to use this function.
Factory default setting
:
(No input)