User's Manual

5. Setup and Status Display
38
NZ2WL - xxx
■
Scan Channels
This item is available when you choose the channel to scan. Selecting the "Scan Channels" might
shorten the scan time and make a roaming smoothly. Enter each channel with the ",". (Example: 36, 40,
48 to scan the channels of 36, 40, 48 only...) If you want to scan all of the channels that support, leave it
blank. Normally, you do not have to change the default setting.
Factory default setting
:
(Blank)
■
AP Aging Time (s)
Specify the time to hold the information of the access point in the "Wireless node information". If you
want to change from the factory default setting, please perform sufficient validation on the system you
want to use. Normally, you do not have to change the default setting. Enter a value between 10 and 120.
Factory default setting
:
120 (seconds)
■
Original Login Trial Time (s)
This item is available when the wireless link mode is "Standard Infrastructure". Specify the time to try
the "Original Login" when the "Standard Infrastructure" is selected. If you want to change from the
factory default setting, please perform sufficient validation on the system you want to use. Normally,
you do not have to change the default setting. Enter a value between 3 and 60.
Factory default setting
:
60 (seconds)
■
Disconnect Time (s)
If you have lost a beacon while connecting to the access point or failed to connect to another access
point, you can specify the time until it is cut. If you want to change from the factory default setting,
please perform sufficient validation on the system you want to use. Normally, you do not have to
change the default setting. Enter a value between 1 and 10.
Factory default setting
:
10 (seconds)
■
IP Tunnel
This item is available when the wireless link mode is "Standard Infrastructure". When connected to the
access point of the IP address of the device and another segment (IP tunnel state), if you have to
"Enable", discard the broadcasts from different segments received by the wireless LAN without a bridge
to a wired LAN side. If you are on the "Disable", then bridge a broadcast from another segment. If the
IP address in the "Standard Infrastructure" is not the state of the IP tunnel connected to the access point
of another segment, please to "Disable". And, if the IP address to connect to the access point of the same
segment, you do not need to change the setting.
Factory default setting
:
Enable
■
Roaming Notification Retry Count
This item is available when the wireless link mode is "Standard Infrastructure". It will specify the
number of times to retransmit the roaming notification packet of the connected equipment under the
wired LAN. This setting is enabled when "IEEE802.1x", "WPA", "WPA-PSK", "WPA2", "WPA2-
PSK". Retransmission interval is 1 second. Enter a value between 0 and 3.
Factory default setting
: 1