User's Manual

5. Setup and Status Display

NZ2WL - xxx

Factory default setting: 100 (ms)

■

DTIM

This item is available when the unit type is “Access point”. Set the interval at which to add a DTIM

(Delivery Traffic Indication Message) to a beacon signal, which is information for recovering a station

from power-save mode. Enter a value between 1 and 255.

Setting this item to 1 adds a DTIM to each beacon signal and setting it to 2 adds one to every other

beacon signal.

Factory default setting

1 (time)

■

QoS

This function preferentially sends a specific packet, such as VoIP.

This can be used, for example, to provide the optimal environment for an internal IP phone system using

wireless LAN.

To enable the QoS function, set it to "Enable".

Factory default setting

Disable

■

WDS

This item is available when the unit type is “Access point”. To enable the WDS function, set it to

"Enable". In that case, you must specify the wireless MAC addresses of the remote APs with which to

communicate. Use the "Edit List" button to open another window for setup and set the MAC address.

You can register up to six wireless MAC addresses for inter-AP communication.

When specifying a MAC address, enter a hyphen (-) at intervals of two characters.

(Example: 01-23-45-67-89-ab)

The types of encryption available for wireless LAN setup are WEP, AES, and AES-OCB. WPA cannot

be used. In addition, the IEEE 802.1X function cannot be used in conjunction.

The WDS function cannot be used when channel 56, 60 or 64 has been selected for IEEE 802.11a. Use a

different channel.

Factory default setting

Disable

Encryption that can be used is WEP, AES (WPA no such), and AES-OCB only. WPA functions can not

be used. In addition, it can not be mixed with IEEE802.1X function.

■

Power-save Mode

This item is available when the unit type is "Station". To enable power-save mode, set it to "Enable".

Enabling power-save mode can reduce power consumption of wireless devices. This is effective when

operating on battery power, but it reduces performance, so it is recommended that normally this be set

to "Disable".

Factory default setting

Disable