User's Manual

5. Setup and Status Display
32
NZ2WL - xxx
■
Unit Type
Select either “Access point” or “Station”.
Factory default setting
:
Access point
Table 5.2. Unit type
Unit type Overview
Access point Master access point controlling other stations or access points operating in station mode.
Station Access points controlled by (logged into) another access point. For use when using as a bridge, for example.
■
XR function
To enable the XR (eXtended Range) function, set to “set to “Enable”.
When the XR function is enabled, the transmission rate is fixed to “Automatic”.
Factory default setting
:
Disable
▼
Details
■
ESSID
The name of the wireless LAN to which the AP belongs. Enter a name within 32 alphanumeric
characters. The name is case sensitive.
When the unit type is "Station", set ESSID same as the access point which wants to log in.
Factory default setting
:
LocalGroup
■
Channel
This item is available when the unit type is “Access point”. Select the wireless channel to use. Select
from among the available channels for the country where used. The following are the available
channels.
Factory default setting
:
(depends on the country where used)
Table 5.3. Country channels
Standard
Channel*1
U.S.A.
(NZ2WL-US)
Europe
(NZ2WL-EU)
China (NZ2WL-
CN)
Korea
(NZ2WL-KR)
Taiwan (NZ2WL-
TW)
IEEE802.11a
36, 40, 44, 48,
149, 153, 157, 161,
165ch
36, 40, 44, 48ch
149, 153, 157, 161,
165ch
36, 40, 44,
149, 153, 157,
161ch
149, 153, 157, 161,
165ch
IEEE802.11b/g 1-11ch 1-13ch 1-13ch 1-13ch 1-11ch
*1 The channels of this product can be changed only among the same models.