User's Manual

2. Setup
NZ2WL - xxx
5
Table 2.2. During File Write
LED name Status LED display
POWER
Flashing
simultaneously
File write in progress *1
WLAN
*1 Except writing of log files (no flashing)
Do not restart or turn off the module during the File writing.
Table 2.3. Error Display
LED name Status LED display
POWER Flashing twice
Wireless LAN error
WLAN ON
DIP switches
Table 2.4. DIP Switches
ON OFF Operation / function
1 INIT -
Turning on this switch flashes the POWER and WLAN LEDs.
If the switch is turned off before the LEDs change their status from flashing to
ON (about 3 seconds), all the settings are restored to the default settings after
the product is started next time. Reboot the product after the LEDs stop
flashing. *1
2 IP LESS -
Turning on this switch allows the product to operate without the IP address
setting. The switch is used when an IP address is not allocated to the product
at the setup of a station. In this case, the TELNET, FTP, settings by Web
browser, and SNMP agent function cannot be used.
*1 The flashing continues for a little while after the product is switched off during initialization
by switching
on and off the INIT switch. This indicates internal memory files are being deleted. The internal memory
files may be damaged and the product may not start up properly if the power is switched off before the
flashing stops. Always reboot the product after the flashing stops.