User's Manual

Professional installation instruction

1. Installation personal:

This product is designed for specific application and needs to be installed by a qualified personal who has RF and related rule

knowledge. The general user shall not attempt to install or change the setting.

2. Installation location:

The product shall be installed at a location where the radiating antenna can be kept 20cm from nearby person in normal operation

condition to meet regulatory RF exposure requirement. Also, the antenna of the module must be installed at a location where the EM

wave can be received or transmitted freely without the blocking by the final house or any internal/external object(s). Preferably be seated

above the final device to make sure radar signal can be detected without reduce in sensitivity.

3. External antenna:

Use only the antennas which have been approved by the applicant. The non-approved antenna(s) may produce unwanted spurious or

excessive RF transmitting power which may lead to the violation of FCC limit and is prohibited.

4. Installation procedure:

Please refer to user’s manual for the detail.

5. Warning:

Please carefully select the installation position and make sure that the final output power does not exceed the limit set force in relevant

rules. The violation of the rule could lead to serious federal penalty

CONTEC CO.,LTD.

3-9-31, Himesato, Nishiyodogawa-ku, Osaka 555-0025, Japan

201

Editio

Japanese http://www.contec.co.jp/ Englis

ttp://www.contec.com/

Chinese http://www.contec.com.cn/

A01967

(

LYNZ931

)

[

511201

]

o part of this document may be copied or reproduced in any form by any means without prior written consent of CONTEC CO., LT