User Manual

8. Appecdix
70
FX-DS540-APDL-U
Table 8.1. Initial setup list (4/4)
Setting item Setting contents(First default)
< Extensions >
Bridge Packet Control (MAX 32 entries) Disable, Enable [List edit : MAX 32 entires]
Network time, function Disable, Enabled
Network time, IP address (IP address of network time server)
Network time, time zone +09:00 (Japanese time zone is between +09:00.)
Access control
Access control, TELNET Enabled, Disable
Access control, FTP Enabled, Disable
Access control, WEB server Enabled, Disable
Access control, administrator IP Disable, Enabled
Access control, administrator IP address1 0.0.0.0
Access control, administrator IP address2 0.0.0.0
<Terminal>
Baud rate 9600, 1200, 2400, 4800, 19200, 38400, 57600, 115200
<SNMP>
SNMP agent function Disable, Enabled
Community name (Single-byte alphanumeric
characters can be up to 32 characters long and .the
password is case sensitive.)
public
Access permission Read/Write, Read Only
Trap destination IP address (1 point) 0.0.0.0
Administrator contact information (sysContact)
(Blank), (The string can be up to 32 characters long when all the
characters are single-byte characters or up to 16 characters long
when they are all double-byte characters.)
Device location (sysLocation)
(Blank), (The string can be up to 32 characters long when all the
characters are single-byte characters or up to 16 characters long
when they are all double-byte characters.)
Device name (sysName)
(Blank), (The string can be up to 32 characters long when all the
characters are single-byte characters or up to 16 characters long
when they are all double-byte characters.)
<Log function>
Log function Disable, Enabled
Overwriting mode Enabled, Disable
Beginning day/time setting
Beginning day/time setting function
Disable, Enabled
Beginning day/time setting Beginning day/time Year Month Day Time Minutes
Log setting in detail log-in ON, OFF
Log setting in detail log-out ON, OFF
Log setting in detail log-in rejection ON, OFF
Log setting in detail Roaming ON, OFF
11g: The function when selecting IEEE802.11g.
AP: The function when unit type is access point.
ST: The function when unit type is station.