User Manual

4. Setup Preparation
44
FX-DS540-APDL-U
Setting the IP address
(1) Select [2. Setup].
Figure 4.6. IP Address Setting Screen
(2) Select [3. IP Address] and enter the IP address assigned to the AP on the wired LAN.
(3) Select [4. Sub-Net Mask] and enter the sub-net mask for the IP address set in step 2.
(4) Select [5. Default Gateway] and enter the IP address of the default gateway.
You do not need to enter an IP address if there is no default gateway.
(5) Press the [W] key or return to the top menu and select [3. Writing] to save the settings, then enter
[BYE] or return to the top menu and select [1. Exit] to disconnect the terminal.
After restarting the AP, setting is enable.
This completes network setup. You can now use a web browser for setup and perform network
management using SNMP.