User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
FX-DS110-APL
vi
List of Figures
List of FiguresList of Figures
List of Figures
Figure 2.1. Component Locations.................................................7
Figure 2.2. Multi-channel Operation...........................................10
Figure 2.3. Channel Frequencies................................................. 11
Figure 3.1. ADHOC Mode..........................................................13
Figure 3.2. Infrastructure Mode ..................................................14
Figure 4.1. Wall Installation........................................................17
Figure 4.2. Attaching Magnets....................................................18
Figure 4.3. Removing Magnets...................................................18
Figure 4.4. Installation on a Steel Desk ......................................19
Figure 4.5. Cable Connection......................................................20
Figure 4.6. Power Supply Connection ........................................21
Figure 4.7. Ground Connection...................................................22
Figure 5.1. Main Menu................................................................24
Figure 5.2. Edit............................................................................25
Figure 5.3. Configuration............................................................26
Figure 5.4. Firmware...................................................................27
Figure 5.5. Status.........................................................................28
Figure 6.1. Sample STA Application ..........................................43
Figure 6.2. After STA Application..............................................44
Figure 6.3. Reconfigured After STA Application.......................45
Figure 7.1. Settings......................................................................49
Figure 9.1. External Dimensions.................................................56