User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
SNMP Agent Functions
FX-DS110-APL
49
Building-in to SNMPc
Follow these steps to install SNMPc Ver. 4.
(1) Start the SNMPc Setup.program.
To start SNMPc Ver. 4, select [Start] – [SNMPc 4.0] – [Setup].
After startup, verify the user registration information.
(2) Insert the Maintenance Tools floppy disk provided with this
product into the floppy disk drive. Enter the floppy disk
drive path name followed by SNMPc.4\, and click 'OK.'
Example: If the floppy disk drive is the A: drive, enter
A:\SNMPc.4\.
(3) Select [CONTEC FX-DS110-APL], and click [OK] to start
installation.
(4) When the following message appears, click [No] to exit the
program.
[Do you want to install additional vendors?]
MIB Database Updates
After installing a new vendor, you will have to update the MIB
database the next time SNMPc is started.
Follow these steps to update the MIB database. In this description
we use 'SNMPc Ver.4' as an example.
(1) Start SNMPc.
To start SNMPc Ver. 4, select [Start] – [SNMPc 4.0] –
[SNMPc].
(2) Click [Yes] to update the MIB database.
(3) When you are finished updating the MIB database, click [OK].
The build-in to SNMPc is not complete.