User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
36
To Use Data scramble Functions for Better Security
(1) Start the utility software. From the main menu, select
Configuration, and then select the access point you wish to edit
from the access point name list.
*Once an APL on the network has been located using Search,
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
(2) On the Base tab, use the Data Scramble checkbox and set the
scramble key.
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.
To Use SNMP Agent Functions
(1) Start the utility software. From the main menu, select
Configuration, and then select the access point you wish to edit
from the access point name list.
*Once an APL on the network has been located using Search,
its settings are stored in a file. It is not necessary to use
Search each time the utility software is started.
(2) On the SNMP tab, make the necessary settings (Community
Name, Access, Send Trap, Name, Location, Contact).
(3) When the settings are complete, select [Write]. The settings
will be valid when the device is rebooted.