User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
34
Other Settings
Password (Activated by the 'Password' key on the
Configuration window)
Changes the password setting for this AP.
･ Current password
Enter the current password setting for this AP.
Factory setting: No setting
Input values: Up to 6 alphanumeric characters, case sensitive.
･ New password
Enter the new password.
Input values: Up to 6 alphanumeric characters, case sensitive.
･ Confirm password
For confirmation, enter the new password again.
The new password will only be established for the access point if it
is correctly entered twice. The new password will be effective
when the access point is restarted.
Input values: Up to 6 alphanumeric characters, case sensitive.
Enter Password
This box is displayed to require password entry for access to the
access point such as reading or writing setting values, firmware
maintenance, etc.
Input values: Up to 6 alphanumeric characters, case sensitive.
Default ([Default] key on the Settings screen)
Displays the default settings for IP address, subnet mask, and
default gateway on the screen. To apply these values, use the
[Write] key to write the values, then the [Reboot] key to reboot.