User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
32
Contact
This setting records contact information for the manager of this access
point, such as the network manager's name or telephone number.
Factory setting: No setting entered
Input values: Maximum 31 characters
Spanning Tree
Enable Spanning Tree
This setting determines whether the spanning tree function is used. It is
valid only when the network mode is 'ADHOC (Simple Mode).'
Factory setting: Checked (Use)
Bridge Priority
The lower the value of this setting, the higher the priority of this access
point in the spanning tree. Changing this priority will change the root
bridge of all bridges in the network.
Factory setting: 32768
Input values: 0 to 65535
BPDU (Bridge Protocol Data Unit) Max Age Time
The BPDU max age time determines the maximum length of time
that this access point can be used before the information obtained from
the BPDU is discarded.
Factory setting: 20 seconds
Input values: 6 to 40 seconds
BPDU (Bridge Protocol Data Unit) Hello Time
The BPDU hello time determines the interval over which the BPDU
transmits when it is the root, or attempting to be the root, of this access
point.
Factory setting: 2 seconds
Input values: 1 to 10 seconds