User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
31
SNMP
Community Name
This is an SNMP recognizable character string, which functions
like a password for access to the access point from an SNMP.
Programs can access the access point MIB by using this community
name.
Factory setting: [public]
Input values: Up to 31 alphabetic characters, case sensitive.
Access
This setting determines the access authority for the community.
The selection is between 'Read Only' access or 'Read & Write'
access.
Factory setting: [Read & Write]
Send Trap
This setting determines whether the SNMP agent system will notify
the user of errors such as access right errors, or APL startup.
Factory setting: Unchecked (Do not send trap).
･ IP Address: Enter the IP address of the user to which the trap
is to be sent.
Name
This setting determines the name of this access point on the SNMP.
Factory setting: No setting entered
Input values: Maximum 31 characters
Location
This setting records the physical location of the access point, such
as "8F R&D Department."
Factory setting: No setting entered
Input values: Maximum 31 characters