User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
28
Setting Descriptions
Edit
Access Point
Giving a name to an access point makes it easier to identify on the
network.
Names may be up to 32 characters. A maximum of 1024 names
may be entered.
Base
IP Address
Enter the IP address of the home station. This is written on the
seal on the bottom of each unit at the factory. This setting is not
necessary to use the APL as a wireless device, but if it is used in
combination with APE, or if the APL is accessed through different
routers, the IP address must be entered.
Factory setting: A unique value is assigned using the lower 3 bytes
of the 6-byte APL Ethernet address.
(Example) Ethernet address IP address
[00-80-4C-01-02-03]
→
[10.1.2.3]
[00-80-4C-0D-0E-0F]
→
[10.13.14.15]
The initial '10' is common to all settings.
Subnet Mask
If a subnet is used, enter the subnet mask number.
Factory setting: [255.0.0.0]
Default Gateway
This setting determines the IP address of the network router to
which this unit belongs.
Factory setting: [0.0.0.0]