User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Setup
FX-DS110-APL
16
4. Setup
Wall Installation
Using the Mounting Screws (Included)
Place the screws in the wall according to the mounting diagram,
then mount the unit.
It is also possible to remove the cover from the unit, then remove
the wireless card and screw the unit onto the wall directly.
Diagram 1
(1) Place the screws in the wall according to the mounting diagram
(2 screws).
(2) Position the AP unit so that the two wall mount holes in the AP unit
fit over the two screws in the wall.
(3) Slide the AP unit down to hold it in place.
(1) Press here to open the lid.
(2) Slide the cover in the direction shown and release the
catch. Remove the wireless card.
(3) Insert the screw to attach the unit. After mounting,
replace the wireless card and cover.
(1)
(2)
(3)
(3)
Diagram 2
(1)
(1)
(2)
Figure 4.1. Wall Installation
Note!
Do not obstruct the ventilation slits. This can cause the
temperature inside the product to rise and can damage the
components inside.
Caution!
Do not install this unit upside down. This will
cause heat to accumulate and possible cause fire.
POWER
WRX
WLINK
LINK
RX