User Manual
Table Of Contents
- Copyright
 - Trademarks
 - Product Configuration
 - Introduction
 - Overview
 - Operating Mode Descriptions
 - Setup
 - Settings
- Preparing the Utility Software
 - Utility Software Settings
 - Setting Descriptions
 - To Register or Set Up a New Access Point
 - To Edit Settings for an Existing Access Point
 - To Use Data scramble Functions for Better Security
 - To Use SNMP Agent Functions
 - To Use Spanning Tree
 - To Access the APL from a Different Router
 
 - Spanning Tree Algorithms (STA)
- What is an STA?
 - STA Parameters
 - Sample STA Application
- _
- All settings other than bridge priority settings are identical.
 - The root bridge is determined by the priority settings of each ...
 - The designated bridge for each LAN segment is determined by roo...
 - The designated port for each bridge is determined by the design...
 - The root port of each bridge is determined by its path cost to ...
 - Ports that are neither designated ports nor root ports are back...
 
 
 - _
 
 - SNMP Agent Functions
 - Troubleshooting
 - Appendix
- Product Specifications
 - Input/Output Interface
 - Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
 - IEEE 802.11/ IEEE 802.11b
 - MIB (Management Information Base)
 - SNMP (Simple Network Management Protocol)
 - Diversity
 - Router
 - Bridge
 - LAN (Local Area Network)
 - RSSI (Receive Signal Strength Indication)
 - Spectrum diffusion transmission
 - DS (Direct Sequence)
 - CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
 - Hidden Terminal Problem
 - RTS (Request to Send)
 - Roaming
 - Peer-To-Peer
 - AP (Access Point)
 - User Unit
 - ESS ID (Extended Service Set ID)
 - Channel
 
 
 - _
 
 - Index
 
 Overview 
FX-DS110-APL 
7 
LED Indicators 
Table 2.1.    ADHOC (Simple Mode) 
Flashing Startup, or startup error
On Operating
WLINK On Operating
WRX Flashing Receiving wireless LAN data
LINK On Wire LAN connection normal
RX Flashing Receiving wire LAN data
Name Status Indicator
POWER
Table 2.2.    Infrastructure (Standard Mode) [Unit Type AP] 
Flashing Startup, or startup error
On Operating
WLINK On Wireless LAN connection normal
WRX Flashing Receiving wireless LAN data
LINK On Wire LAN link connection normal
RX Flashing Receiving wire LAN data
POWER
Name Status Indicator
Table 2.3.    Infrastructure (Standard Mode) [Unit Type Station] 
Flashing Startup, or startup error
On Operating
WLINK On Wireless LAN connection normal
WRX Flashing Receiving wireless LAN data
LINK On Wire LAN link connection normal
RX Flashing Receiving wire LAN data
POWER
Name Status Indicator
Table 2.4.    Other 
Flashing 2 times Initialization error
Flashing 3 times Firmware writing error
POWER
WLINK
WRX
All flashing
at the same time
Firmware writing in progress
Name Status Indicator
POWER










