User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Introduction
FX-DS110-APL
4
Precautions Related to Electromagnetic Interference
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions : (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment complies with part 15 of the FCC rules. Any changes of
modifications not expressly approved by the manufacturer could void
the user’s authority to operate the equipment.
CAUTION: To comply with FCC RF exposure compliance
requirements, a separation distance of at least 5 cm must be
maintained between this device and all persons.
Precautions Related to Service
Clean the FX-DS110-APL by wiping lightly with a soft cloth moistened
with water or a cleaning solution.
Take care to avoid the use of benzene, thinners or other volatile
solutions which may cause deformation or discoloration.
Notes!
･
The unauthorized reproduction of this document, in whole or in part, is
prohibited.
･
The specifications, designs, and other contents of this document are
subject to change without notice.
･
The contents of this document are believed to be accurate, however if
any discrepancies noted should be brought to the attention of the store
where this product was purchased.
･
Notwithstanding the foregoing, the manufacturer is unable to accept
any claims for losses or lost profits, etc. Resulting from the use of this
product.
･
MS, Microsoft, Windows, Windows NT, and MS-DOS are registered
trademarks or trademarks of Microsoft Corporation in the U.S.A. and
other countries.
Netscape Navigator is a registered trademark of Netscape
Communications.
Other names of companies and products used in this document
trademarks or registered trademarks of the related companies. This
document does not use the symbols ™ , ® , © etc.