Operation Manual

Medical Test Supply www.medicaltestsupply.com
10
Note
Wait 4-5 minutes between measurements
 The arm may have congestion following a measurement which may cause incorrect
blood pressure readings. After the blood flow is re-established, take a measurement
once again.
 When some factors affect the measurement results in measurement process, error
messages hints will appear on the screen, you can obviate the malfunction and
restart a measurement.
In no physiological alarm state, press any button to carry on the corresponding button function;
in audio alarm state, press any button (except 【ON/OFF】 button) to clear up the audio alarm.
Take off the cuff, hold ④ 【ON/OFF】 button to turn the device off.
*The device will automatically turn off after two minutes in which there is no operation to
the device, even if you forget to turn the power off.
Chapter11 Memory Function
The device is designed to store and display the blood pressure, pulse rate values and the date and
time when measured, which are up to 100 items. If there have been 100 items stored, when the
101 measurement have been taken, the earliest results are deleted.
11.1 Review the Memory Value
1. In the main interface (interface when boot-strap), press 【MEMORY】 button to review the
most recent measurement values in large-print with the serial number from 1 to 100.
2.Press 【UP】/【DOWN】 button to circularly switch the former measurement values.
*The right figure shows that there is no Measurement result.