User's Manual

6
When the device enters into case review interface, it will display the latest sampled case.
Click the button to review other cases information. The device can store 99 pieces of cases at
most. If reaches to the limit, new stored case will cover the original case, the one that stored at
the earliest, piece by piece.
The device will automatically turn to sampling interface to continue if the user holding
the electrode at both ends again when the device is under the case review interface.
3) Battery Operation Notes
4) Li-battery
Battery Voltage: DC 3.7V 530mAh. The device can continuously work for more than 4
hours when battery is completely charged.The cycle life of the battery up to 300 times.
Two method for charging:
(a) Connect the device with a computer by using Micro USB cable, charging completed
after about 2~4 hours.
(b) Use a Micro USB to connect the device with a power adapter (output current＞
500mA, 5V), charging completed after about 2 hours.
(c) The connected power supply shall be in compliance with IEC 60950-1standard.
Battery display
(d)
5) Auto power off
The device will automatically shut down after no operations within 1 minutes.
4.3 Sync software operations
Users can operate in the PC synchronous software according to necessary, which including
sample mode and time setting, upload case, case review, measurement, print, etc. Please refer to
operation directions of PC synchronous software for details.
4.4 accessories list
No. Description Quantity
1 Host 1
2 USB cable 1
No. Indicator Description
a full power
b capacity : 3/4
c
capacity: 1/2
d
capacity : 1/4
e
Using battery, low power, it is recommended to recharge the
battery.The device will automatically shut down.