Product guide

7
Installation
Installing the Lamp
The Showtec Sky Rose 2500 uses the 2500W (ordercode 80903O / 80903P / 80903S) bulb as manufactured
by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Procedure :
1. Loosen the 6 screws on the housing. Gently remove the metal housing.
2. Loosen the 4 screws on the housing and slide the cover to the left side.
3. Loosen the 1 screw on the housing.
4. Slide the cover to the right side.
5. Carefully remove the old lamp. Read lamp instructions. Do not touch the lamp bulb glass.
Oil on hands shortens the lamp life. (If you touch the bulb glass, wipe off the glass with a clean, lint-free
towel and rubbing alcohol.). Insert the lamp.
6. Gently turn the screw to fasten the light bulb.
7. Now do the previous steps in reverse order.