Technical data

On Auto, the shutter speed is set automatically according to the subject

brightness and on the basis of the preselected lens aperture. It varies

continuously and, therefore, provides precise exposure even at in-between

speed. On manual operation, however, the shutter will not function at in-

between speed settings.

Switch to manual operation in the following instances:

· When photographing by preselecting a precise shutter speed.

· In flash photography.

· In B (bulb) photography.

1. Turn the shutter control dial away from the 'AUTO' setting. The green

shutter speed pointer will then move away from the 'A' setting in the

viewfinder.

2. Set the required shutter speed setting in alignment with the index. When

thus adjusted the green pointer will overlap the corresponding setting of the

shutter speed scale visible in the viewfinder.

3. Press the LED display pushbutton and check the position of the LED dot.

4. Turn the aperture ring until the LED dot aligns with the preset shutter speed

indicated by the green pointer.

5. When the LED dot is properly aligned with the green pointer, press the

magnetic release to trip the shutter.

· On manual operation, the correct exposure can also be obtained through

preseleclion of the lens aperture. In this case, preset the f-stop and then press

the LED display pushbutton. While observing the position of the LED dot,

turn the shutter control dial until the green pointer aligns with the dot.

· In case two LED dots come on simultaneously, turn the aperture ring until a

single dot aligns with the green pointer.