Technical data

at the 'AUTO' setting.

If the LED dot comes on in alignment with 'A' or 'B', incorrect exposure is indicated; therefore, the lens aperture and/

or shutter speed setting must be readjusted accordingly.

When the green pointer overlaps the 'A' setting, it means that the camera is set for fully automatic exposure. In case

the shutter control dial is adjusted to any position other than the 'AUTO' setting, the green pointer will overlap the

figure corresponding to the shutter control dial setting.

Exposure compensation tab

When the film speed dial is turned and the exposure compensation pointer is aligned with any setting other than 'X1',

this tab appears on the lower edge of the finder frame to signal that exposure compensation is being made.

FOCUSING

To secure focus, turn the focusing ring of the lens while sighting

through the viewfinder until the main subject appears clearly defined.

The microprism focusing spot at the center of the finder field affords

utmost convenience and ease in focusing. Precise focus is secured

when the multiple glitter disappears and the image of the subject

within the focusing spot appears sharp and clear.

· The viewfinder of your CONTAX RTS affords viewing and

focusing always at maximum aperture. To check the depth of field

after securing precise focus, simply push in the depth-of-field preview

button.

The method of focusing remains the same regardless of what type of

lens or combination of the Auto Extension Tubes is used.

· When necessary, the standard screen featuring the microprism

focusing spot can be interchanged with any one of the four types of

focusing screens available as optional accessories