Technical data

4. After making sure that the shutter control dial is set at a position

other than the 'AUTO' setting, advance the film until the sprocket teeth

properly catch the perforations along both edges of the film. Then,

close and press the back cover until it locks into place.

5. Fold out the film rewind crank-handle and turn it in the direction of

the arrow to take up the film slack.

* When folded, the crank-handle will rotate freely; therefore, make

sure it is returned into the compartment above the 'AUTO' setting.

6. Press the magnetic release and advance the film, alternately, until

the exposure counter registers the figured'

If the white line on the film rewind knob rotates when the film

advance lever is manipulated, it means the film is advancing

properly.

CAUTION

Avoid keeping the LED display pushbutton depressed when

advancing the film. Particularly in case the Real Time Winder is in

use, make it a rule to keep your finger off the LED display

pushbutton when making exposure.