Technical data

After removing the body cap and the lens rear cap, set the lens
properly in the mount by matching the red dot on the lens
barrel with that on the camera body. Then, give the lens a right
turn until it click stops into place.
To prevent hitches in focusing and exposure control, always
make sure the lens is locked properly in its mount.
Lens Interchanging
To remove the lens from its mount, twist it to the left while
keeping the lens release button depressed.
Before removing, make it a rule to place the lens cap over the
lens to prevent inadvertent scratching or smearing of the lens
surface. After removing the lens from its mount, cover the rear
end with the lens rear cap.
· Avoid direct sunlight when interchanging lenses, particularly
in case the camera is loaded with film.
· Set the body cap in the lens mount in case the camera is to be
left without it's lens.